RimCraft's Max G Spray System is a full size machine for High Output GFRG spray-up operations. It is available with a 2 or 3 section extended reach boom with a 10 Ft and up to an 18 Ft radius.

The 3 piece boom (max C3) unit is built on a larger, more stable base for the extra length. This system is designed for use with either Premix or Chopped Fiber spray

With no-flat 14” tires in the rear and large Urethane covered casters in the front, this unit can easily traverse rough factory floors.

RimCraft's patented process allows you to retard the Gypsum to give you longer working time while providing you a controllable set time by injecting the Accelerator at the gun. This process is fully explained here on our FAQ page

​

Features

• Highly Maneuverable GFRG Sprayer with Long Overhead Reach for use on Large Molds

• 32 MM RimSpray Peristaltic Pump for E-Z Clean-Out and Ability to Spray Fiber and Aggregate Slurries

• RimCraft Concentric G Gypsum Chopper Gun with Integral Accelerator Injection

• 3 Gallon SS Accelerator Tank with Flowmeter for Precise Metering

• Quick Knockdown pump for Super-EZ (5 minute) Hose change. No drive train disassembly required

• Water-Tite Control Box with Variable Speed AC Motor Drive

• 2 HP 208/230 VAC 3 Phase Motor Direct Gear Drive with Forward and Reverse is Standard. Other Voltages and Phases are Available

• 20 CFM @ 90 PSI Air, Fresh Water (garden hose hook-up) and 208/230 VAC 3 Phase 20 Amp Circuit Required (Other Voltages and Single Phase Available)

• 30 ft. Power Cord

• Fresh Water Purge for Spray Gun Air Passages with Washdown Hose Included

• 30 Gallon Covered Plastic Material Hopper with Easy Clean-Out

• E-Z Clean Slurry Passages with 3 Clean-Out Pigs (sponges) Included

• Optional: available External Mix Chopper Gun

• Optional configurations available

Minimum System Requirements: Garden Hose Connection; Power; 3 Phase 208-230V; 1 Phase 220V; Other Voltages Available; Air Compressor; Minimum CFM 20 at 90 PSI

​

WATCH THIS IN ACTION